Telescopic Belt Conveyor

45°seriesABCLap speed 1 rpm=mmFrame height
330AXL788-45°254788330329178
686AXL965-45°610965686329178
737AX1042-45°6611042737489216
1092AX1524-45°101615241092489216
991AXH1524-45°9151524991648305
1600AXH2286-45°152422861600648305
30°seriesABCLap speed 1 rpm=mmFrame height
330AXL945-30°254945330329178
686AXL1253-30°6101253686329178
737AX1511-30°6611511737489216
1092AX1819-30°101618191092489216
991AXH1928-30°9151928991648305
1600AXH2456-30°152424561600648305

 

Angled belt conveyors are specifically designed for either merge or distribute operation. The number of rollers and their locations are different in these two different types of Angled belt conveyors. A merge equipment cannot be later converted to operate as a distribute equipment. Distribute Angled belt conveyors generally have a longer minimum length than a merge Angled belt conveyor. Check the factory for the minimum length of a specific conveying width and merge/distribute configuration

Model Designations

Typical model designation is written as follows:

850AXH1500-45 LHM

850 is the conveying width (between sideguards)

AX indicates that it is an airless Angled belt conveyor

H indicates that is has a High-Frame (305 mm)

1500 is the centerline length

45 is the angle of the angle bar

LH is the direction of the product after it crosses the angle bar (right-hand direction would use RH)

M indicates that the angle bar is on the exit end of the conveyor (a diverge would use D)

Frame height is indicated in the model designation as follows:

L indicates a 178 mm high Low-Frame model

H indicates a 305 mm high High-Frame model

If an “L” or “H” is not used, it is a 216 mm high Mid-Frame model.

AF indicates that it is an Angled belt conveyor with an air angle bar

ABH indicates that it is an airless Angled belt conveyor with heighten frame, meet the needs of airport baggage handling system